New features in v2.57

Preview individual drive cycles in Plot Route

You are now able to preview individual drive cycles with ease in the "Plot route"-tool. All drive cycles for the currently searched out interval are listed, and can be selected to be previewed individually.

No longer possible to add new tasks for WCUs which are shelved or have shelving in progress

As of this version it is no longer possible to add new tasks to a WCU with the system labels shelving_in_progress or shelving_done. If such a WCU is selected it is marked red in the selected WCU's table. However, if the latter label is present it is possible to unshelve the WCU using the corresponding button in the bottom panel of the Vehicle-tab. Read more about shelving here.

New module settings added for Signal Reader

For WCUs of version >=2.57 it is possible to set whether or not the MDF-files are to be written upon recorder stop, whether or not 22 service requests are to be aggregated and the default OBD-II period in ms. More information is found here.

Add comment to acknowledged alarms

As of this version it is possible to add comments to acknowledged alarms. Read more about this feature here.

SWDL pre and post sequence files

You are now able to add sequence files to run through IDC before and after your SWDL-assignment. This also requires that the targetted WCU has at least version 2.57. More information can be found here.

Audio level trigger for Audio assignments

Triggering on audio level is now available for Audio assignments targetting 2.57 (or later) WCUs. More information can be found here.

New module setting added for Audio

From this version forward audio device can be set to either internal or USB in the module configuration view, see further documentation here.