New features in v2.64

New assignment type and module Ethernet Capture

This new assignment type is used to capture data on ethernet interfaces. To capture traffic on such interfaces, you use capture expression as for tcpdump, see examples here. To read more on the new assignment see here.

Support for reading engine hours using j1939 for state of health (SoH) assignment

There is now support to read the engine hours using the j1939 protocol. The value is available in the result file as well as a system label 'engine_hours'. Read more in creating an SoH task.

Vehicle Profiles can now be copied

It is now possible to copy vehicle profiles. This makes it easier to create new Vehicle Profiles that are only a little bit different from an existing one. Read more about it here.

Alarm Tab support multiple selection

It is now possible to mark several alarms and then Acknowledge them. Read more about the Alarm tab here.

Show number of satellites in WCU Status

In WCU Status you can plot the number of satellites and it is possible to see over larger interval thanks to the resolution change dynamic. Read more about GPS in WCU Status here.

Width of view is now possible to change between absolute/relative width

It is now possible to save for a view in Vehicles, Task, and User panel if the width should fit inside the window or if the width should be static. Read more here.

Administrate the standard view for new user

As admin you can manage the default views a new user will have in vehicles, task, and user panel. It is also possible to apply the default views even if you do not have admin access. Read more here.