New features in v2.64

New assignment type and module Ethernet Capture

This new assignment type is used to capture data on ethernet interfaces. To capture traffic on such interfaces, you use capture expression as for tcpdump, see examples here. To read more on the new assignment see here.

Support for reading engine hours using j1939 for state of health (SoH) assignment

There is now support to read the engine hours using the j1939 protocol. The value is available in the result file as well as a system label 'engine_hours'. Read more in creating an SoH task.

Vehicle Profiles can now be copied

It is now possible to copy vehicle profiles. This makes it easier to create new Vehicle Profiles that are only a little bit different from an existing one. Read more about it here.

Alarm Tab support for multiple select of alarms

It is now possible to select multiple alarms and then acknowledge them. Read more about the Alarm tab here.

Show number of satellites in view in WCU Status

In WCU Status you can plot the number of satellites the WCU has in its view and it is possible to see over larger interval thanks to the dynamic resolution selection. Read more about GPS in WCU Status here.

Width of view now supports both absolute and relative width

It is now possible to save a view in Vehicles, Tasks, and Users panel if the width should fit inside the window or if the width should be absolute. Read more here.

Administer standard views for new users

As an administrator you can manage the default views a new user will have in vehicles, tasks, and users panel. It is also possible to apply the default views even if you do not have admin access. Read more here.

Change between miles and km in vehicles panel

It is now possible to change between km and miles for column Mileage and Distance. Right click on the column header and choose "change to km/miles". If miles are selected it will display "(mi)" after the headers title. The unit applies for both columns.

ECU List highlight differences

The ECU list will no longer highlight a difference if the ECU did not respond last time.

All readouts with number of changes will be populated directly without having to click each date. Read more about ECU list here.

Show when modules was last changed and by whom

The module configuration panel now shows when a module was changed and by whom, see here.