PLA-compression window
In PLA-Compressions level the pla value can be set. The signal that was markt will be automatic select but it is possible to select another signal, trigger and measurement setup.
Signals show information about the signals, if it knows the data, Max and min value and which unit. When changing the PLA value it will show how the selected signal will be affected, both percent and absolute value.
Input PLA value: Enter the PLA value between 0 and 1 in decimal number
- Global PLA - Set a global PLA value thats affect all signal in the assignment
- Measurement PLA - Will affect the signals in the Measurement
- Recorder PLA - Will affect the signals that is in the trigger
- Signal PLA - Will only affect the selected Signal in that specific Trigger
A specific signal will take the first value that is defined in this order: Signal, Recorder, Measurement, Global.
The PLA value can be disable for the selected signal by unchecking the checkbox “Enable PLA”. By clicking on “Enable/disable PLA for multiple signals” a new window will show up where several signals can be disabled and enabled at the same time.
Example if there are 2 signals in a Recorder, Signal A and B. If the Recorder PLA sets to 0.01 it will affect both signal A and B and the will both get 0.01. In case of a new value in Signal PLA will be set to 0.05 for signal B the result will be: PLA signal A - 0.01, signal B - 0.05.